1. Cao H, Wei P, Yue L, et al. Differences in adhesive wear mechanisms of soft/hard materials caused by varying loads during the friction process[J]. Tribology International, 2025: 111157.
2. Cao H, Tian Y, Meng Y. A fracture-induced adhesive wear criterion and its application to the simulation of wear process of the point contacts under mixed lubrication condition[J]. Facta Universitatis, Series: Mechanical Engineering, 2021, 19(1): 023-038.
3. Cao H, Khan Z, Meng Y. Comparison of rolling contact fatigue life between elastohydrodynamic lubricated point contacts pre and post running-in treatment[J]. Tribology International, 2020, 144: 106089.
4. Cao H, Meng Y. Electrochemical effect on boundary lubrication of ZDDP additive blended in propylene carbonate/diethyl succinate[J]. Tribology International, 2018, 126: 229-239.
5. Fang J, Cao H, Bai P, et al. High-pressure rheological properties of polyalphaolefin and ester oil blends and their impact on lubrication[J]. Tribology International, 2025, 201: 110262.
6. Zhang Y, Cao H, Kovalev A, et al. Numerical running-in method for modifying cylindrical roller profile under mixed lubrication of finite line contacts[J]. Journal of Tribology, 2019, 141(4): 041401.
7. Li S, Cao H, Zhao H, et al. Multifunctional oleophilicity coatings fabricated from hyperbranched polymers to achieve high anti-settling of magnetorheological fluids with less magnetism loss[J]. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2025: 138025.
8. Cao R, Liu C, Cao H, et al. Effect of Running-In Conditions on the Super Low EHD Sliding Friction of Si3N4 Ball and WC Plate in Glycerol–Water Solution[J]. Tribology Letters, 2023, 71(4): 124.
9. Meng Y, Yue L, Cao H, et al. Tribological behavior of steel-silicon nitride combinations using chlorophenyl silicone oil (CPSO) lubricant in a wide temperature range of− 100℃ to 380℃[J]. Tribology International, 2025, 204: 110458.
10. Cao R, Bai H, Cao H, et al. Mixed lubrication analysis of tapered roller bearings and crowning profile optimization based on numerical running-in method[J]. Lubricants, 2023, 11(3): 97.
